Magellan MSS Installationshandbuch PDF herunterladen (Seite 14)

STEP 19

Use of a long, narrow drill bit is needed

to drill the hole from inside of the

vehicle.

Before you start your pre-drill hole,

make sure that you will not be drilling

into anything on top of the roof.

STEP 20 - You will be using a hole saw to make

a hole large enough to run the cables through the

roof. Note how the hole you drilled from inside

will be the guide hole for your hole saw.

STEP 21 – Be patient while you are drilling and

only drill as far as there is resistance to your

drilling.

WARNING - Be careful in not drilling into foam insulation or open space under the roof with the hole

saw. The idea is to not drill into any cables running in the space between the ceiling inside and the roof.

Use a pocket knife to remove any other materials. Use your finger to move any cable(s) out of the way

from the hole you will be making in the ceiling panel.

STEP 22 – Use sandpaper or a file to remove any

burrs that could cut into the cables.

STEP 23 – Use the same hole saw to drill from

inside of the vehicle. This makes for a cleaner

hole.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 24 25

Keine Kommentare

Magellan MSS Installationshandbuch Seite 14